You may install the rock lights inside or outside of your vehicle using the included hardware.
First, select the location you wish to install the rock lights on your vehicle. Determine what rock light wire length is needed for each location back to the wiring harness prior to installing. If needed additional extension wires may be purchased.
Prior to drilling or screwing, double check the screw length to make sure they will not interfere with any parts of the vehicle on the backside.
Once the locations and rock light wire lengths have been determined, run the wire through the rubber mounting pad. Afterwards install the screw style you wish to use for mounting through the small black screw holder followed by the light and rubber pad. If needed pre-drill a smaller hole in the mounting surface to allow for the screw. Secure the light and rubber pad with the screw to the mounting surface.
On the back of the mounting surface add the washer and nut. Tighten to confirm the light is secure once both screws are installed. Repeat for each side and rock light.
We make it easy to install up to 8 RGB rock lights by using one bluetooth control box. This allows all wires to run to one location.
Determine the location for the controller box and run each wire back to this module after the lights have been installed. Confirm the wiring harness will reach the vehicle's battery or power source from the controller location. Also, the switch will reach the desired mounting location or rely.
Connect each rock light to a plug and play connector. Tighten to make sure that the wire and waterproof connector are properly secure.
If needed mount or secure the bluetooth controller to the vehicle.
Run the power switch to the desired location. The switch may be removed and wiring harness spliced if connecting to a rely or switch panel. Consult your relay or controller for proper installation instructions.
Connect the wiring harness to your vehicle's battery or the power source for the rock or underglow lights.
The red wire should be connected to the positive terminal on the battery. The black wire connects to the negative battery terminal.
Remove the protective film on the lights prior to connecting power or turning them on.
Once you have all lights secured and connected, switch installed, and wiring harness connected to the power source, you're ready to turn on your RGB rock lights.
Final step is connecting your bluetooth controller to your phone or device using the instructions below.
